|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
We received the manual in a timely manner and it was exactly what we were expecting. Excellent replacement for original Service Manual.
All schematics are very legible. We are really satisfied.
;
We received the manual in a timely manner and it was exactly what we were expecting. Excellent replacement for original Service Manual.
All schematics are very legible. We are really satisfied.
;
Fast delivery and good quality manual.
Very easily downloadable from a given url.
Will be pleased to buy again from this seller.
;
Ottimo manuale, grafica ferfetta invio rapidissimo. Altissimo livello!!!!!
;
Great PDF easy to read good info needed for replacment of belts and assembly and specs.
J. TURNTABLE MOTOR REMOVAL
1) Remove the turntable. 2) Remove the turntable shaft VERY CAREFULLY with a slotted screw driver. 3) Lay the set down on its back. 4) Remove the turntable motor cover. The turntable motor base cover is easily removed by pinching the six parts with a wire cutting. 5) Disconnect the lead wires from the turntable motor terminals. 6) Remove two screws securing the turntable motor to the oven cavity assembly. 7) Lift the turntable motor and mount turntable motor. 8) After repairing the motor, fit the turntable motor cover's projecting part to the base plate's slit.
K. INTERLOCK SYSTEM
1) INTERLOCK MECHANISM The door lock mechanism is a device which has been specially designed to completely eliminate microwave activity when the door is opened during cooking and thus to prevent the danger resulting from the microwave leakage. 2) MOUNTING OF THE PRIMARY, MONITOR AND SECONDARY SWITCH TO THE LATCH BOARD
ADJUSTMENT DIRECTION
PRIMARY SWITCH
MONITOR SWITCH
SECONDARY SWITCH
3) INSTALLATION AND ADJUSTMENT OF THE LATCH BOARD TO THE OVEN ASSEMBLY
q q
Mount the latch board to the oven assembly. Adjust the latch board in the arrow direction so the oven door will not have any play in it when the door is closed. Tighten the mounting screw. Check for play in the door by pushing the door release button. Door movement should be less than 0.5mm. (1/64inch) Don't push the door release button while making adjustment. Make sure that the latch moves smoothly after adjustment are completed and that the screws are tight. Make sure the primary/monitor/secondary switch operate properly by following the continuity test procedure.
q q
16
|
|
|
> |
|
